What's This?

[cmpulse170]

Guy's
I was changing out a fuel line and noticed a hose cut off on a 90 degree fitting. Does anyone know what/where this would go or attach to?
This on my '99 Merc EFI 200 HP.

[powerstroker]

its not capped off is it? Does it look like a hose was cut off or just a rubber boot cap?

[cmpulse170]

its not capped off is it? Does it look like a hose was cut off or just a rubber boot cap?

I'm pretty sure it's a cut hose. I'll verify that tomorrow after work.

[2springers26]

same block as a carbed 200....... carbed engines have bleed line to reciculate fuel.... Efi's have them capped off on 2.5 efi production engines.... it's normal..kurt

[83PREDICTOR]

Could it be for your h2o psi or temp?

[ross]

not sure on that efi but on my carbed 200 merc the water psi is on the top of the block between the two heads....there was a plug i had to remove(3/4inch) and get an adapter to fit the hose(3/8)the hose is a(1/4")!

[175checkmate]

Its a fitting for a carb model. There is another one right behind the elect module. On the carb model there is a hose connected to them. The hose runs from the fitting for the intake manifold right behind the reeds. It provides a vac/pressure signal. No need for this on the EFI model.

[cmpulse170]

Its a fitting for a carb model. There is another one right behind the elect module. On the carb model there is a hose connected to them. The hose runs from the fitting for the intake manifold right behind the reeds. It provides a vac/pressure signal. No need for this on the EFI model.

I thought it was a vacuum line as well, but since this is my first EFI I wasn't sure. My Water pressure hose is on the other side on the same line as the poppet valve close to the block. I'll get pictures for later today.