XXXXXXXXXXXX

[BOB'S 283]

can i determine my x position without the drive mounted ? was under the impression it was measured from cavitation plate .i'm still in pieces. summers comming , summers comming !!!

[BOB'S 283]

can i determine my x position without the drive mounted ? was under the impression it was measured from cavitation plate .i'm still in pieces. summers comming , summers comming !!!

[Dave's ZT260]

Measure from the center of the 2nd bolt hole down on the transom to the bottom of the hull. Use a strait edge on the hull bottom to measure to. If your transom is angled measure strait down instead of following the angle. This number will be in the 15"-17" range.

Hope this helps- Let us know....