• Welcome to the Checkmate Community Forums forums.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
    By joining our free community you will be able to:

    » Interact with over 10,000 Checkmate Fanatics from around the world!
    » Post topics and messages
    » Post and view photos
    » Communicate privately with other members
    » Access our extensive gallery of old Checkmate brochures located in our Media Gallery
    » Browse the various pictures in our Checkmate photo gallery

    Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.

Recent content by equillibrium88

  1. E

    Mercury Black Max 150hp

    How hard is it to expose the water pump? How do you tell if it is working or not? I know very little about boats or boat motors. Learning as I go. The engine has a little pisser tube coming out the back of the cowling, I never see water coming out of there unless the engine is in the lake...
  2. E

    81 Enticer help

    I still have not measured my mid-section but from looking at it, there is no way it is 25" long. For the steering, I replaced the boats stock system with an Anti-Feedback system to make it safer. If I do not have water shooting out of the pisser tube, does that mean I have no water pump...
  3. E

    81 Enticer help

    Thanks for the prompt reply fellas. I measured the jackplate and it sticks out nearly 6" from the transom. The prop-shaft is sitting approx 5" below the pad so I am going to raise it 2" and then see how it drives. I do have a pisser tube, but most of my gauges don't work. When I look at the...
  4. E

    81 Enticer help

    Hello. I am totally new here, hoping to get some good advice about setting up propshaft height on my Enticer. My boat has a manual jack plate on it. It does not have one threaded bolt with two nuts like a lot of the ones I have been seeing. Instead it has two threaded rods on the outside of...
Back
Top