• Welcome to the Checkmate Community Forums forums.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
    By joining our free community you will be able to:

    » Interact with over 10,000 Checkmate Fanatics from around the world!
    » Post topics and messages
    » Post and view photos
    » Communicate privately with other members
    » Access our extensive gallery of old Checkmate brochures located in our Media Gallery
    » Browse the various pictures in our Checkmate photo gallery

    Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.

Will my Checkmate XX fit in my garage or barn?

JW

Moderator
Staff member
This question occasionally comes up so I thought I'd start a thread where we can post our model and dimensions. It's been raining so much in SW Michigan that I pulled my boat off the lift a while ago and put it under my carport. Today is pouring rain again, so it's 'cleanup in the garage' day. After I got it maneuvered into half the messy garage, I remembered to measure it out.

Quick description: Pulsare 1850 with ETEC 150 mounted on a 6" CMC manual lift Jack plate. Trailer has folding tongue, most forward part of trailer with tongue folded is the winch. Boat is a hair wider than the trailer so I'll use the factory published hull width. Engine is trimmed to about level, so it's possible to gain some room fiddling with the trim.

Length: 262", which is just shy of 22'
Height with ski tripod installed: 77"
Width: 100"
 

Attachments

  • image.jpg
    image.jpg
    65.1 KB · Views: 59
Great thread ! I ask this ques a lot mainly because of garage space ! The pain in a$$ of my current garage space 3 car but the p.o. Put in small doors so boat has to go in 3rd bay on diagonal through the double door for summer then shuffle it snugly over to wall for winter time ,just because it can't fit through 3rd bay ! Just under 24' deep
 
  • Like
Reactions: JW
My 2000 BRX with 250 ProXS & 12.5" setback on Phoenix trailer with fold-away tongue just barely fits into 24-ft garage. Otherwise a 7-ft high garage door has enough vertical clearance for it to fit through.
 
  • Like
Reactions: JW
My 242 sitting on its c hawk trailer needs between 29 to 30' of building. My shop is 32' which works out perfectly.
 
  • Like
Reactions: JW
My 253 with the drive trimmed all the way up sitting on a junk B&M Haul Rite trailer is just over 32' long total. We built a 14.5' x 35' addition to the barn at the lake and put in a 12' garage door. She fits perfectly in there with plenty of room to walk around and work on the boat. I'm hoping with a new trailer with possibly a swing away tongue I will be able to fit the golf cart in front of it.
 
  • Like
Reactions: JW
1988 Starflite on a 1988 C-Hawk single axle trailer with 1988 Mercury 200 (bolted to transom, no setback) takes all of 25'-2" from end to end. My garage is 26' deep (exterior) so it JUST fits with maybe an inch or two on each end. When we were considering buying the house, the realtor asked why I was measuring the garage so many times!
 
Back
Top