• Welcome to the Checkmate Community Forums forums.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
    By joining our free community you will be able to:

    » Interact with over 10,000 Checkmate Fanatics from around the world!
    » Post topics and messages
    » Post and view photos
    » Communicate privately with other members
    » Access our extensive gallery of old Checkmate brochures located in our Media Gallery
    » Browse the various pictures in our Checkmate photo gallery

    Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.

270 convincor hull ?

PA-Checkmate

PA-Checkmate

Active member
Why does where the transom and hull bottom meet have an angled what looks to be 45*? It's a 2002 and also has notched transom which I'm aware of that advantages.

thanks
 
senator-holland said:
Dont have a answer to this. Dont know how to measure it.

What speed are you running with your set up?
Click to expand...

I think it should run almost 70mph, but only have an hour of seat time. I purchased in October when the season was over. Just need to wait until spring.

What's yours run?
 
Craig said:
I believe it just makes it easier to remove it from the mold.

-craid
Click to expand...

That’s what I believe, I remember the subject being brought up with kip and his answer was that and hard to keep that corner sharp and debris free in the mold
 
Its also for more speed as the mix air/water is going to be better for drag. Its little but it helps. The later convinsors have them. 2000 and up.
 
You must log in or register to reply here.
Back
Top