• Welcome to the Checkmate Community Forums forums.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
    By joining our free community you will be able to:

    » Interact with over 10,000 Checkmate Fanatics from around the world!
    » Post topics and messages
    » Post and view photos
    » Communicate privately with other members
    » Access our extensive gallery of old Checkmate brochures located in our Media Gallery
    » Browse the various pictures in our Checkmate photo gallery

    Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.

Checkmate pulsar 2100 with 250 optimax xs

My guess would be in the 75-80 MPH range if you nail the setup.
icon_smile.gif
 
65.3 is a little bit slow for that combo. My 200efi Pulsare ran 66 on radar bone stock. My 225efi runs 73 on gps. With the same setup, the extra 25hp should gain 5 mph. If the elevation is high where you are, that would explain the low top end. The lake that I normally run on is 1652 ft. above sea level. boatman
 
My gps speedometer is dead on! Checked with 4 different radar gun's. Needforspeed303 is also using gps. So I would say pretty accurate. boatman
 
Originally posted by claupie:
HOW ACCURATE IS A SPEDOMETER ON A PULSAR REALY IS??
Hey Claupie, My Mercury Speedometer is pretty accurate with the handheld Garmin GPS right up to 70mph, than the speedo starts boucing a bit.
 
Originally posted by boatman4021:
65.3 is a little bit slow for that combo. My 200efi Pulsare ran 66 on radar bone stock. My 225efi runs 73 on gps. With the same setup, the extra 25hp should gain 5 mph. If the elevation is high where you are, that would explain the low top end. The lake that I normally run on is 1652 ft. above sea level. boatman

Hey Boatman, what is the settup on your Pulsare? I'm also running a Merc 225 Xri (efi), 7.5" of set back, Merc/DAH 26 chopper, Hyd. jack. When I raise the jack all the way my prop shaft is about 2" below the pad.
 
Hey Jupiter, I have a 10" cmc manual jack plate and a set of 2" spacers. The engine is mounted as high on the jack plate as it will go and the plate is maxed out. Best I can tell, 3 1/2" below the pad. 73mph is with less than 1/2 tank of gas, by my self, with a box stock 26" Trophy Plus @5600rpm. I'm also running at 1650ft above sea level. boatman
 
The merc speedo in my first Pulsare said 75 whan the radar gun said 66. I don't think any 2 read the same. That's why I bought the Intellitronics gps speedo. boatman
 
My new 2100 Longdeck runs 72-74 on GPS and a 26 Trophy with a 225 Optimax. Speedo shows 79-80 mph. I took the 300x off because it was way too impractical, and a pain in the butt to drive at 85 plus. The Opti can get 6mpg at 40-50mph. I run 16.5 inches of setback with a hydraulic jackplate.
I'd think that the 250xs should run at least 80mph.
 
Chris, my friend who once owned the 2100 B/R Now owned by another fellow on this site had it up to 77 MPH (GPS Verified) with a stock 225 Opti. However the front bow section was ripped out and replaced (with new padding) and there was a custom bow cover and a hi-po prop but it's achievable.

A 250 XS would be a great motor combo for that boat
icon_smile.gif
 
I know every boat and set-up is different, but my guess is that 77 with a 225 was at very near sea level or at least under 1000'. I would love to make mine run 77 on our local lake. That's why I would like to have a 300X!
brickwall.gif
 
Back
Top