groundloop
Active member
You can open an account on photobucket, upload your photos there, then paste the link in your thread (with the "insert image" button at the top of the "reply to thread" area) so that the photos show up full size (about 500 pixels wide, give or take, works out well).
Anyway, your moving right along and it's looking good.
It's strange how your transom seems to have had that slight curve/angle. On my Eluder the transom was cut down to only 1 inch thick in the area that butted up to the splashwell. I measured and measured the original transom before attacking the new one with a router.
. both sides are done and will prime them tomorro to keep them from rusting. heheheheh
it is great to get on here and read. i hope yall enjoy. it looks like i have already found me another mate. need to finish this first...
i am a welder and my dad worked in the oilfield and my brother owns a cabinet shop. a long story short, is i got the pipe from dad and built me a wood burning 
. hhehehe thanks for the support . p.s. when it was snowing, i was in shorts in my shop. yall please keep post comming this is awsome for me.
i just cant seem to get anything done. heheheh. sometimes i realy try to make the wife realy mad so she will send me outside, it makes her feel good. 
and the make up s_x is great. it is a win/win for me.
tommorro i am gona build some retainer plates for the bolts that hold down my seats, no backup wrench will be needed and i can seal off hole in wood with some silicone then glass them over. i will post a pic tommorro to show yall an idear that some one may be able to use. it will all be stainless steel. then i will finish glassing the floor and off to the dash board i will go. i already have a few diffrent plans for dash, just need to pick one. yall have a gooood night and sleep tight....
